SHEARS - STACKERS - TABLES

STRIP SHEAR
This is the heart of the cutting line. Depending on the sections, the types of materials handled and the required cutting rate, a mechanical, pneumatic or hydraulic operation shear will be chosen.
The quality of its design will allow a minimal cutting burr and will limit the frequency of sharpening.

STRIP END SHEAR
Recommended for wide or thick strips, the addition of a shear after the straightener or feeder allows the strip ends to be cut off in complete safety.
The shear helps to reduce the production changeover time: it allows easier removal of the cutting tool and facilitates the recoiling and joining operations.
Available in widths of 300 to 1525 mm.

EDGE TRIMMING SHEARS AND SCRAP CHOPPERS
For shearing the cutting scrap, we build pneumatic 1708 and motor-driven 1716 mechanical lever shears.
DIMECO also offer type 1735 edge trimming
shears and motor-driven scrap recoilers.

STACKERS
DIMECO offer an economical range (GL) of simple and effective stackers. The length of the stacked blanks can reach 5 m, with width adjustable up to 2000 mm. The stacker can be completed with a pneumatic cylinder jogging device (DDT).
The stack is built up on one or more elevator tables (TEX) equipped with a servo-control for automatic stacking at constant level.